EIGHT 7-pole Canon Precision DC motor 12V FN30 series . Japan

Description

EIGHT   Canon motors, 12v DC ,   6,300 rpm  7 pole
30 mm  rounded,  single shaft
High power output, low mechanical/electrical noise, high speed response
Body: 30mm Dia. X 41mm (L).
Shaft: Ø4mm X 12mm
No Load Speed =
6300rpm
,
Rated Road/Speed = 75g-cm/4650rpm,
Stall Torque =
270g-cm
These are practically  never used.
Was fitted to a locomotive model that could not accommodate a flywheel/double shaft.
So, we had to saw off one shaft .   But we later found a way around the problem.
So, these motors were removed and replaced by the double shafts.
note: somebody didn't take instructions properly when removing the motors.
The two terminals were partially cut .  Does not affect performance, though.
Originally purchased directly from Canon factory in Japan.
These are now offered at  less than 1/2 of my original cost when I bought in lot of 1,000s
If the specs fit your need, these are the finest motors you can find .  These motors are used mostly in quality instruments and equipments.  Smooth and quiet operation and quick response. ALL are tested and lubed before shipping.
note: most have worms on. they can be removed with heat .  just heat and pull off the shaft  or cut with Dremel.